S60 L5-2.4L VIN 64 B5244S6 (2003)
Hint: When diagnostic trouble code (DTC) E001 is stored, communication with the control module cannot be established. This can be remedied in two
ways.
1. Press the remote control button for local lighting
2. Remove fuse 11C/28 from the fusebox in the passenger compartment. Reinstall the fuse again.
Continue - Checking the interior lighting
-------------------------------------------------
Checking the interior lighting
Checking the interior lighting (2)
Checking the interior lighting
Two times can be programmed for the interior lighting:
1. Short
-
The period from when the door is unlocked, or the engine stops, to when the interior lighting goes out can be changed if it is too long or too short.
2. Long
-
The period from when the door is opened, or a lamp is lit with a switch, to when the lamp goes out can be changed if it is too long or too short.
To program a long interior lighting period you must step ("click") through the short interior lighting period programming.
Continue - Programming a short interior lighting period
------------------------
Programming a short interior lighting period
The general lighting and rear reading lamps light and remain lit for 30 seconds when:
-
The door has been unlocked from outside with a key or the remote control.
-
The engine has been stopped and the ignition key turned to 0.
The default period is 30 seconds. This can be changed to between 5 and 255 seconds.
