S60 L5-2.4L VIN 64 B5244S6 (2003)
Make a cut out in the plates on the left and right hand sides in the bumper rail to make room for the outer sensors.
Right-hand side:
Cut out one plate (1) as shown in the figure.
Left-hand side:
Cut out both plates (2).
-
Place the bumper rail in the bumper cover above the foam rubber. At the same time route the cable harness (1) through the hole (2) in the bumper
rail
-
Reinstall the antenna connector (3) in the bumper rail
-
Check that the outer sensors are unimpeded by the bumper rail. If not, cut further
-
Press the bumper rail into place in the foam in the bumper cover. Ensure that the hooks have engaged. Secure all the catches in the top edge of the
bumper.