S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Cut off the rubber bushing (1)
-
Lift the bumper into position
-
Route the cable harness for the sensors through the hole in the outer panel for the rear cross member
-
Route the cable harness in the gap between the inner and outer panel for the cross member towards the right. Continue out through the round hole
(positioned above the hole for the connector for the antenna cable) under the right tail lamp
-
Take the rubber seal previously removed in point. Cut the rubber seal as illustrated
-
Press the rubber seal into the rear cross member, around the cable harness for the sensors.
Installing the rear bumper
-
If the mountings (1) have released from the rear edge of the wheel arch, reinstall them: press the mountings fully into the grooves. Screw the screw
in a few turns
-
Reinstall the bumper by pressing it forwards. Ensure that the four screws protruding from the bumper align in the holes on the car
-
Before the bumper is completely installed, slide the top edge (2) into the grooves. Then slide the bumper fully in.
