S60 L5-2.4L VIN 64 B5244S6 (2003)
Hold the float arm in the centre position and press the level sensor into position.
Installing the fuel pump (FP)
Lower the pump into the tank.
Install:
-
the fuel hose
-
the three connectors.
Turn the pump to the installation position. Install the mounting bracket and screw. (M6)
Install the cover.
Use special tool 999 5720 Wrench See: Tools and Equipment/999 5720 Wrench.
For tightening torques, see Tightening torque See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening Torque.
Note! Check that the arrow on the cap ends up between the markings on the tank. If the arrow ends up outside the markings it will result in the
tank gauge indicating the wrong value and the float may jam against the tank's inner wall.
Installing the cover for the level sensor/fuel pump (FP)
Install:
-
the cover
-
the insulation panel.
Reinstall the carpet.
Finishing
Install:
-
the backrest
-
the screw for the hinge mounting (M10)
-
the connector for the hinge
-
the end mounting for the seat belt.
For tightening torques, see Tightening torque See: Body and Frame/Specifications.
Install the side cushion.
(V70) Fold the seat cushion forward.
(S80, S60) Install the seat cushion.
