S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Turn the ignition key to position 0.
-
Install the trailer connector with the three screws and the nuts. Tighten.
-
Ensure that the cable harness is as close to the centre mounting on the tow bar member as possible. This is important to prevent the cable harness
from being caught in the cut-out bumper.
-
Secure the cable with a tie strap.
Applies to the S80
-
Turn the ignition key to position 0.
-
Install the trailer connector (1). Use the three screws (2) and the nuts (3). Tighten.
-
Route the cable harness behind the screw (4) on top of the tow bar. Then route the cable harness down past the bracket (5).
-
Clamp the cable harness at the bracket. Tighten the clamps (6).
Installing the connector for fixed tow bars
Applies to the S60
-
Install the trailer connector (1). Use the three screws (2) and the nuts (3). Tighten.
-
Leave the bracket hanging down as illustrated
