S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Secure the cable harness with a tie strap on the sides of the tow bar member brackets.
Figure B applies to cars with R-design Skidplate
On cars with Skidplate, the contact shall be turned 90° counter-clockwise in relation to the placement in Figure A.
Steps 7-16 apply to the S60
-
Fold back the carpet.
-
Remove the clips on the lower edge of the folding panel (on both the right-hand and left-hand sides) by pressing in the centre of the clip until an
audible snap is heard.
-
Remove the clips.
-
Unscrew the front clips.
-
Turn the knob (1) on the right-hand and left-hand sides 90°.
-
Fold the panels inwards. Lift the panels out.
-
First, pull the trunk lid sill trim panel (2) forwards until the two clips on the right-hand and left-hand sides release. Pull forcefully but carefully
since the panel is fitted tightly. Pull the panel straight up until the four clips in the lower edge release.
-
Remove the wiring (3) for the cargo compartment lighting.
