S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Following the diagram, mark where the hole will be drilled for the bracket for the connector
-
Pre-drill using a smaller drill bit. Then drill out the hole. Use a
6.5 mm (1/4") diameter drill bit
-
Remove any swarf. Rust-proof the edges of the holes.
-
Take the screw and the nut from the kit
-
Position the bracket and the connector over the drilled hole
-
If the bracket does not fit: mark on the bumper cover where the corner (1) needs to be cut away, then cut it. If the car has a protective panel on the
rear bumper, this may also need to be filed off
-
Tighten the bracket for the tow hitch member.
-
Lift up the floor hatch (1). Lift up the storage hatch (2). Remove these two hatches from the car
-
Remove the side panel (3) on the left-hand side.
