S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Route the cable harness from the tow bar connector through the hole in the floor
-
Adjust the position of the rubber seal (2) so that there is not too much slack in the cable under the car
-
Install the rubber seal in the hole
-
Route the cable as illustrated. Clamp the existing cable harness in the sill trim panel. Ensure that the cable harness is not impeded by the battery
holder and the protective cover
-
Install the new holder for the connector (see illustration B)
-
Connect the cable harness connector (1) to the existing connector (3)
-
Secure the two connected connectors (4) in the existing hole in the bodywork.
Reinstall:
-
the protective cover and the bracket for the battery (see point 7)
-
the side panel, the storage compartment and the floor hatch (see point 6).
Checking the 4-pin connector:
Tow Hitch Wiring, 7-Pin
Tow Hitch Wiring, 7-pin
