S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Pull the bumper backwards slightly. Bend out the sides (1) so that they detach from the mountings (2). Then pull the bumper backwards until it
detaches completely
-
Place the bumper on a suitable underlay that will not damage the paint.
Remove:
-
the rivet (1) on the bracket (2) for the silencer. Use cutting nippers
-
the screws (3) on the bracket
-
the bracket by detaching the rubber mountings (4). The bracket will not be used again.
-
Remove the screws (1) and the bracket (2) from the rear right side of the car The bracket will not be used again.
-
Apply masking tape (1) to the outside of the bumper to avoid damage from the saw. Install masking tape opposite where the cutting will occur and
over the bumper cover as illustrated
-
Leave the masking tape in place throughout the installation procedure
-
Saw according to the markings on the inside of the bumper as illustrated
-
After cutting, even off the edges using a file.
Installing the fixed tow hitch (including the cable harness)
