S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm. Angle-tighten 90 degrees. Use bevel protractor 951
2050. Tighten the rear screw. Tighten to 105 Nm. Angle-tighten 90 degrees
-
the anti-roll bar. Tighten to 60 Nm
-
the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm. Angle-tighten 60 degrees
-
the mounting for the heated oxygen sensor (HO2S) wiring
-
the engine pad.
Install new pipe/hose holders.
Installing the sub-frame
-
Position the sub-frame on a lifting table
-
Carefully lift the sub-frame
-
Locate the control arms on the ball joints and the steering gear on its mountings
-
Remove the hook (999 5045) that is holding the steering gear
-
Lift the sub-frame up completely
-
Reinstall the engine block heater (if applicable).