S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Press the screw using a screwdriver until the loose end pieces on the inside of the bumper cover are pressed backwards
-
Carefully drill out the rivets (2) underneath the bumper on both sides. Use a - 6 mm (1/4") diameter drill bit. Do not damage any of the plastic
components.
-
Pull the bumper backwards slightly. Bend out the sides (1) so that they detach from the mountings (2). Then pull the bumper backwards until it
detaches completely
-
Place the bumper on a suitable underlay that will not damage the paint.
Remove:
-
the rivet (1) on the bracket (2) for the silencer. Use cutting nippers
-
the screws (3) on the bracket
-
the bracket by detaching the rubber mountings (4). The bracket will not be used again.
-
Remove the screws (1) and the bracket (2) from the rear of the car, right-hand side. The bracket will not be used again.