S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Ensure that the sun blind is against the front door post (1) before pressing the sun blind down and against the door panel.
-
The mounting for the sun blind must be inserted and pressed down between the mounting plate and the door panel using a twisting movement as
illustrated. Do NOT press down vertically only. Press the sun blind down against the door panel until a click is heard. The lower edge of the sun
blind mountings must grip around the edge of the door panel as illustrated.
-
Remove the mounting plates.
-
Check that the sun blind is against the door panel. If the sun blind is not against the door panel, press the sun blind down further.
-
Position the hook 3 mm (1/8") behind the front limit position of the hook.
-
Clean the marked surface on the inside of the window using a wet wipe (from the kit). Allow the window to dry.
-
Install the marking tape on the inside of the window in front of the hook and 2 mm (5/64") under and parallel with the upper edge of the window
as illustrated. (The hook must remain in the same position behind its front limit position.)
-
Hang the hook up centrally over the marking tape on the window. The hook must always hang over the centre of the marking tape when using the
sun blind.
-
Repeat points 1 - 5 for the other sun blind.
Function test
-
Check the function. Raise and lower the side window.
