S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Brake Fluid Pressure Sensor/Switch: Description and Operation
Brake Pressure Sensor (Only DSTC)
Two brake pressure sensors are positioned on the master cylinder. One sensor is located on the primary circuit and one on the secondary circuit. The
information is transmitted via two analog signals (measurement range 0-5 V) and is used by the ABS control module to calculate the brake pressure
during DSTC control, and when the driver applies the brakes.
The sensors receive voltage via the ABS control module. There are diagnostics for the sensors. When replacing the brake pressure sensor the ABS
control module must be calibrated according to the information in VADIS vehicle communication or manually via a test drive.
