S60 2.4 L5-2.4L VIN 61 B5244S (2001)
3
Removing the cylinder head
All variants:
Remove the cylinder head, see VADIS:
Installation Function
Function group 21
Replacing the cylinder head/gasket.
4
Removing the pistons
Note!
On later version engines the connecting rod and the end cap
mating surfaces are aligned by a dedicated fracture surface. Note the
markings on the connecting rod and the end caps
and the direction in which they are installed, forward,
rearward, left, right.
On earlier version engines the connecting rod and end cap mating
surfaces are aligned by serrations. NOT all connecting rods and
end caps may be marked as described above. If markings are in place
then note location as described above. If NO markings exist stamp
or etch the appropriate cylinder number on each all facing the
same direction.
Turn the crankshaft to bottom dead center to access the two
connecting rod cap bolts.
Remove the end cap bolts.