S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Crankshaft Main Bearing Seal: Service and Repair
M56 Transmission
Crankshaft seal rear, replacing
Special tools: 999 5112, 999 5651, 999 1801, 999 5678, 999 5676, 951 2050
Note: As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the
essential information is always correct.
Removing the flywheel and carrier plate
Remove the transmission:
-
manual transmissions.
-
automatic transmissions.
Remove the flywheel / carrier plate. Use gear sector 999 5112 as a counterhold when slackening off the screws.
Removing the seal
Note: Do not damage the mating surfaces of the crankshaft and cylinder block
Remove the old seal using extractor 999 5651.
Clean around the crankshaft flange at the front and rear. Remove any thread sealant residue from the screw holes.
If necessary wash off the oil on the rear cylinder block surface and the transmission clutch housing. Blow clean using compressed air.
