S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Note: Check that the locating pin on the crankshaft is positioned opposite the hole in the flywheel / carrier plate. The position of the guide hole is
marked.
Caution: It is important that the flywheel and carrier plate bear on the crankshaft flange before the other screws are installed. Always use new
screws. Ensure that the thread sealant on the new screws is intact. If not apply a few drops of sealant 1161056 to the thread.
-
Align gear sector: 999 5112
-
Pull the flywheel / carrier plate towards the crankshaft using the 3 nuts on special tool 999 5678. The turned section of the nut must be turned
towards the flywheel / carrier plate.
-
Install the other screws. Tighten.
-
Replace the 3 special screws with new standard screws. Tighten.
-
Then angle-tighten all 10 screws crosswise. Use 951 2050. Tighten.
-
Ensure that the flywheel sensor and bracket are installed. Install the clutch driven plate and clutch.
Installing the transmission
Install the transmission:
-
manual transmissions.
-
automatic transmissions.
Checking the engine: Test drive the car to check the function of the engine and the transmission.
