S60 2.4 L5-2.4L VIN 61 B5244S (2001)
surfaces for the flywheel / carrier plate are clean. Ensure
that there is no thread sealant residue in the screw holes.
Install:
-
the flywheel and carrier plate
-
the 3 studs 999 5678, position as illustrated. Turn
the short thread length towards the crankshaft.
Note!
Check that the locating pin on the crankshaft is
positioned opposite the hole in the flywheel / carrier
plate. The position of the guide hole is marked.
7
Tightening the flywheel/carrier plate
Install gear sector 999 5112.
Pull the flywheel towards the crankshaft using the 3 nuts
on tool 999 5678. The turned section of the nut must be
facing the flywheel/carrier plate.
Caution!
It is important that the flywheel and carrier plate
bear on the crankshaft flange before the other screws
are installed.
Caution!
Always use new screws. Ensure that the thread sealant
on the new screws is intact. If not apply a few drops of
sealant 116 1056 to the thread.
Install the other screws. Tighten crosswise to 45 Nm.
Replace the three special screws with new standard screws.
Tighten crosswise to 45 Nm.
Then angle-tighten all 10 screws crosswise. Use tool
999 2050.
For the flywheel: 65°.
For flex plate: 50°.
Ensure that the flywheel sensor and bracket are installed.
Install the dutch disc and pressure plate.
8