S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Remove the flame sensor.
Cutting and splicing wiring
Cut the wiring and splice. See Splicing the cables See: Diagrams/Diagnostic Aids/Splicing the Cables
Installation
Bleeding the fuel system
Connect the fuel line to a vacuum pump. Suck carefully until fuel comes out. Connect the cables and hoses.
Installing components
Reinstall the components.
Reinstall the heater in reverse order.
Note! Always check that there is clearance between the fuel line and water hose.
Final check
Note! Start the engine and let it idle for a few seconds before starting the heater.
Test run the heater. Check the function of the heater. See Engine coolant heater, test running See: Testing and Inspection/Component Tests and General
Diagnostics/Engine Coolant Heater, Test Running
Check both the coolant hoses and the fuel lines for leakage.
Top up the coolant if necessary.
Check that no diagnostic trouble codes (DTC) have been stored during the repair work.