S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Audible Warning Device: Service and Repair
Replacing the Back-Up (Reversing) Warning Sensor
Replacing The Back-up (reversing) Warning Sensor
Special tools: 981 4214
NOTE: The control module for the back- up (reversing) warning system is in the right wheel arch. The accessory electronic module and, for the V70
and V7OXC, the remote starter unit are also positioned there.
Removal
NOTE: As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.
Removing the side panel
Disconnect the battery negative lead:
CAUTION: When removing and installing the battery leads, see Note when disconnecting/connecting the battery lead.
Remove the side panel on right-hand side.
Disconnecting the connector
CAUTION: The following procedure must be carried out to ensure that the connector and wiring are not damaged when removing the
bumper.
-
Follow the cable from the sensors in the bumper up to the control module for the back-up (reversing) warning system.
-
Remove the control module for the back-up (reversing) warning system. Disconnect the connector (its cable comes from the bumper).
NOTE: Disconnect the correct connector. The control module for the back-up (reversing) warning system has 2 connectors.
Removing rear bumper