S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Take the short flanged screw and the bracket from the kit.
-
Remove the tape concealing the weld nut.
-
Install the bracket with the screw in the weld nut as illustrated, but do not tighten the screw yet.
-
Turn the bracket to maintain a distance of 45 mm between one corner of the bracket and the centre of the hole for the lower ground screw. See the
illustration.
-
Tighten the screw.
Installing the junction connector
-
Remove the engine splash guard.
-
Cut away the engine compartment insulation at the punched metal on the right-hand side down in the engine compartment.
-
Remove the rubber grommet (1) inside the insulation.
-
Cut off the top of the rubber grommet (1).
If an engine block heater is installed