S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Release the catch on the rear. Use a screwdriver
-
Lift and pull out the control module.
Check
Check that the control module's connectors are intact.
Installing the control module
-
Press the control module into place so that the catch on the rear engages
-
Position the connector. Carefully press the connector down.
Note! The pins are fragile. Check that the connector goes straight down into the control module.
-
Tighten the screw for the connector
-
Check that the connector cover is correctly positioned. Remedy if necessary
-
Install the relays and shunts. For relay locations, see instruction Relay location.
-
Install the integrated relay / fusebox, see Installing the integrated relay / fusebox in the cargo compartment.
Ordering software
Order applicable software.
Other information
For the location of other relay and fuse boxes, see Relays, fuse boxes and wiring See: Power and Ground Distribution/Locations.
Interior Lighting and Upper Electronic Module (UEM), Replacing
Interior lighting and upper electronic module (UEM), replacing
Replacing the lens and the bulb