S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
the banjo bolt with new gaskets
-
the oil filler cap.
Raise the car.
Remove the splashguard under the engine
Tighten the banjo bolt. Tighten to 24 Nm.
Tighten the 4 x screws for the electronic throttle module (ETM). Tighten to 10 Nm.
Install the cover under the engine.
Lower the car.
Installing the alternator
Install:
-
the alternator in the correct position
-
the upper screw but do not tighten
-
both the screws common to the alternator and the air condition (A/C) compressor. Do not tighten.
Tighten:
-
the upper screw. Tighten to 24 Nm
-
the lower screws for the air conditioning (A/C) compressor. Tighten to 24 Nm
-
the screws common to the alternator and the air conditioning (A/C) compressor. Tighten to 24 Nm.
Install: