S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Turn the ignition key to position II
-
Reconnect the battery negative lead
-
Reinstall the cargo compartment carpet
-
Reinstall both floor hatches
-
Program the software according to the service information in VIDA.
Central Electronic Module (CEM), Replacing
Central electronic module (CEM), replacing
Exposing and removing relay box in passenger compartment
Caution! The customer-programmed data must be read off before the control module is replaced. The information must then be entered into
the new control module after it has been installed. This is performed via VIDA vehicle communication.
Note! Applies to vehicles -2003, All ignition keys are needed when programming a new control module.
Note! For vehicles equipped with Volvo On Call (see phone's keypad) the battery's minus lead shall be removed first. Otherwise the automatic
alarm for emergency services may be triggered. See Battery, disconnecting See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting
Note! The driver information module (DIM) must not be replaced at the same time. This would erase the mileage.
For further information, see Downloading software and replacing the control module See: Body and Frame/Body Control Systems/Testing and
Inspection/Programming and Relearning/Downloading Software and Replacing the Control Module/Central Electronic Module (CEM)
Removing soundproofing panel on driver's side