S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Ignition off
-
the control module disconnected.
-
Switch off all equipment that takes power from the battery (courtesy lighting, radio etc).
For the Control module, connect an ohmmeter between terminal # 16 on the breakout box and the battery negative terminal.
The ohmmeter should read 0 [ohm].
Yes
-
See:
No
-
See: Checking the Ground Terminal For the Steering Wheel Module/Fault-Tracing Information
Fault-Tracing Information
Fault-tracing information
The fault should be diagnosed and remedied. Since this is not the case the fault-tracing process has failed.
Complete the fault-tracing for those fault or try again.
Do you want to terminate fault-tracing at this time?
Yes
-
See:
No
-
See: Checking the Ground Terminal For the Steering Wheel Module/Connecting the Ground Terminal
Connecting the Breakout Box, Steering Wheel Module (Swm)
Special tools: 951 1463, 981 3190, 951 1508
Connecting the breakout box
-
Ignition off
-
Expose the steering wheel module (SWM) according to Steering Wheel Module (SWM), replacing.
Check that the male and female terminals on the unit connectors are undamaged and secure (cannot be pressed in). Check that the cables to the female
terminals are secured to the terminal pins.
Connect adapter 951 1463 to the control module connector (wiring side). Connect the breakout box.
981 3190 to the adapter, steering wheel module (SWM) terminals # A1 - # A22 correspond to # 1 - # 22 on the breakout box. If the contact reel is to be
checked, connect adapter 951 1508 to breakout box 981 3190. Contact reel terminals # B1 - # B5 correspond to # 26 - # 30 on the breakout box. The
breakout box is designed to facilitate reading off the control module input and output signals when the control module is connected; and the cable and
component resistance when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuited cables and
damage to the connector pins.
