S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Steering Column Control Module: Testing and Inspection
Diagnostics and Tests
Connecting the Ground Terminal
Checking the ground terminal
-
Ignition off
-
the control module disconnected
-
Switch off all equipment that takes power from the battery (courtesy lighting, radio etc).
Connect an ohmmeter between terminal # 16 on the breakout box and the battery negative terminal.
To connect the breakout box, see Connecting the breakout box. See: Connecting the Breakout Box, Steering Wheel Module (Swm)
The ohmmeter should read approximately 0 [ohm].
Ok
-
See:
Not Ok -
See: Checking the Ground Terminal For the Steering Wheel Module/Checking For Open Circuits, Contact Resistance and Oxidation
Checking For Open Circuits, Contact Resistance and Oxidation
Checking for open-circuits, contact resistance and oxidation
For the Control module, check ground terminal 31/84 and the wiring connected to it. Check for an open-circuit. Check for contact resistance and
oxidation.
Other information:
-
Checking wiring and terminals, Permanent faults.
When the fault has been remedied, See: Checking the Ground Terminal For the Steering Wheel Module/Verification
Verification
Verification
