S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Install the new snap ring included in the boot kit.
Installation
Installing new boots on the drive shaft
Install the constant velocity joint on the drive shaft
Ensure that inner ring is straight in the constant velocity joint.
Tap on the constant velocity joint. Use a rubber mallet.
Check that the snap ring is seated in its groove. Do this by measuring the distance according to Checking the dimension.
Greasing the boot
Grease the boot.
Apply the remaining grease from Lubricating the constant velocity joint.
Note! Ensure that there is no grease on the mating surfaces between the boot and the constant velocity joint and the shaft.
Remove excess grease. Use methylated spirit.
Ensure that the boot is in position on the constant velocity joint housing.