S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Connect the new routed DIN cable (1) to the CD changer
-
Connect the pre-routed cable with the blue connector (2) to the CD changer.
Applies to cars with rear acceleration sensors
-
Remove the acceleration sensor behind the left-hand wheel arch
-
Install the CD changer as above. At the same time, reinstall the acceleration sensor in the same rivet nut and screw as before. The sensor must be
above the bracket for the CD changer. Tighten to 24 Nm (18 lbf. ft.).
Note! The acceleration sensor must be securely installed with the connector turned upwards. If the sensor is not secure, movement may
result in false values. This could result in poor system performance when cornering for example.
Applies to all models
-
Install the CD changer. Tighten the screw (3) for the clip with the nut at the rear edge of the wheel house flange. Tighten the screws (4) for the side
member and the rear crossmember.
-
Secure the wiring at the cable harness by the fuse holder and at the left-hand side of the rear cable duct. Use the tie straps (1) from the kit
-
Clamp any cable excess.
Applies to cars up to and including model year -2004 (CH -424999)
