S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
shaft.
Clean the splines on the drive shaft.
Turn in the wheel spindle and locate the drive shaft in the hub.
Install drive shaft screw and finger-tighten.
Lubricate the screw.
-
Loosely install both the screws retaining the spring strut in the wheel spindle. Use new screws and nuts
-
the tie rod end onto the wheel spindle. Use a new nut. Tighten to 70 Nm.
Install
-
Adjust the position of the wheel spindle and spring strut. Tighten to 105 Nm. Angle-tighten 90°. Use bevel protractor 951 2050
-
the anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm. Counterhold with a Torx wrench so that the boot is not damaged
-
the ABS sensor cable
-
ABS sensor onto the wheel spindle. Tighten the ABS sensor. Tighten to 10 Nm.
