S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Note! A click should be heard when connecting. The noise confirms that the catch has locked.
-
Locate the cable harness along the edge inside the bumper cover, above the foam. Secure the cable harness with butyl tape. Use activator (P/N
8637076) as an underlying surface in order to increase adhesion.
-
Reinstall the foam and the plastic in the bumper cover.
-
Make sure that all catches fully engage.
Note! Take care to ensure that the activator has dried, at least ten minutes, before painting.
Applies to the V70
-
Paint the sensors and holders using the same colour code paint as the car. Use paint recommended by Volvo. Apply a maximum of two coats.
-
When the paint has dried, remove the protective backing paper.
Applies to the XC70
-
The inner sensors are painted with paint code: 426 silver. The outer sensors are only painted with clear coat.
-
When the paint has dried, remove the protective backing paper.
Caution! Too many layers of paint may result in partial or complete malfunction. All sensors must be painted to achieve optimum function.
