S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
components.
Remove:
-
the perforated sections of the insulation panel (1) and the nuts (2) for the bumper in the rear cross member
-
the antenna connector (3)
-
the rubber seal (4) covering the hole over the antenna connector. Save the seal as it will be used to lead-in the cable harness for the sensors in the
existing hole.
-
Pull the bumper backwards slightly. Bend out the sides (1) so that they detach from the mountings (2). Then pull the bumper backwards until it
detaches completely.
-
Place the bumper on a suitable underlay that will not damage the paint
-
Install the backing paper evenly distributed over the bumper.
Note! The backing paper is used to protect the paint.
Installing the sensors
