S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
-
Install a new spring nut (from the kit) in the front mounting for the CD changer and bracket if there is not already a welded nut there
-
Position the CD changer and bracket behind the left-hand wheel arch. Tighten using new screws from the kit
Applies to cars with rear acceleration sensors:
-
Remove the acceleration sensor behind the left-hand wheel arch
-
Install the CD changer as above. At the same time, reinstall the acceleration sensor in the same rivet nut and screw as before. The sensor must
be above the bracket for the CD changer. Tighten to 24 Nm (18 lbf. ft.).
Note! The acceleration sensor must be securely installed with the connector turned upwards. If the sensor is not secure, movement may result in
false values. This could result in poor system performance when cornering for example.
Applies to all models
-
Position the CD changer and bracket behind the left-hand wheel arch. Tighten using new screws from the kit.
-
Clamp the wiring at the cable harness. Clamp it by the fuse holder, by the hole in the flange at the rear edge of the wheel arch and at the plastic
hose at the front edge of the wheel arch. Use tie straps (1).
Finishing work
