S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Slacken off:
-
the four mountings (1) in the upper edge of the bumper cover on the left and right-hand sides
-
the ten catches (2) from the upper edge of the bumper cover
-
the eight catches (3) in the upper edge of the bumper cover
-
the seven catches (3) from the lower edge of the bumper cover.
-
Pre-drill the holes through the centre of the markings (1). Use a 3 mm (1/8") diameter drill bit. Drill from the inside of the bumper cover
-
Drill out the hole. Use a 8.5 mm (21/64") diameter drill bit.
-
Enlarge the holes in the bumper cover. Use a 31 mm (17/32") diameter hole cutter (P/N 9814069).
