volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Adapter 7 to 4 Pole Wiring For Towing|Page 21474 > < Adapter 7 to 4 Pole Wiring For Towing|Page 21472
Page 20
background image

-

Fold up the seats in the third row (applies to cars with three rows of seats).

-

Remove the screws (2) for the load securing eyelets in the left-hand side panel.

-

Remove the covers (3) over the front mountings for the left-hand side panel. Pry the covers off. Use a plastic weatherstrip tool or a small
screwdriver.

-

Remove the screws (4).

-

Remove the clip (5) at the bottom of the storage compartment in the panel (Applies to cars with three rows of seats).

-

Remove the panel by pulling out the upper edge slightly so that the clips on the inside release. Pull the panel straight up.

Installation

Applies to the XC90

-

Remove the 20A fuse in the rear fuse holder in terminal F20. Replace it with the 5A fuse from the kit.

-

Disconnect the connector for the cable harness for the towbar.

Adapter 7 to 4 Pole Wiring For Towing|Page 21474 > < Adapter 7 to 4 Pole Wiring For Towing|Page 21472