S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
-
Remove the outer screws on the left side of the sill panel.
-
Pull up the sill panel's left end carefully and insert the two long cables towards the rear member as far as possible.
-
Route as much cable as possible so that the cable with the large ring cable terminal can be connected to the ground terminal in the rear member,
and the cable with the small ring cable terminal to the holder for the main fuses.
Ensure that the cables are positioned so that they cannot be trapped.
-
Tighten the sill trim panel securely.
-
Connect the larger cable terminal to the ground terminal in the rear member. Torque tighten to 24 Nm (18 lbf.ft.).
-
Take a fuse, two nuts and two washers from the kit and install the fuse in any free terminal.
-
Connect the cable with the small ring cable terminal.
-
Install washers and nuts. Torque tighten the nuts to 5 Nm (4 lbf.ft.).
