S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Power Seat Control Module: Component Tests and General Diagnostics
Checking Battery Voltage
Fault-tracing Information
Condition
Possible source
-
Burnt out fuse
-
Open-circuit
-
Short-circuit to ground
-
Short-circuit to supply voltage.
Fault symptom[s]
-
The seat does not function at all.
Connecting The Breakout Box
Connecting The Breakout Box
Special tools:
951 1428
951 1499
951 1507
981 3194
Connecting the breakout box
-
Ignition off.
-
Remove the door panel
-
Disconnect the module connectors.
NOTE: Unplug the 12 pin connector before the 30 pin connector.
Connect the adapter to the control module's connector. Connect breakout box 951 1428 and cable harness 951 1499 to the adapter.
Adapter cable harness 951 1507 is for the 12 pin connector, and adapter cable harness 981 3194 is for the 30 pin connector.
Disconnection of breakout box in reverse order.
Other information
-
To remove the door panel, see Replacing the front door side panel
-
For further information about signals and other values, see Signal specification.
Connecting the Breakout Box, Power Seat Module (PSM)
Connecting The Breakout Box, Power Seat Module (PSM)
Special tools:
951 1463
951 1428
951 1499
951 1507
Connecting the breakout box
-
Ignition off
-
Remove passenger compartment fuse 24 (11C/24) and passenger compartment fuse 4 (11C/4)
-
Remove the power seat module (PSM).
-
Disconnect the module connectors.
There are two adapters for the power seat:
Connect adapter 951 1463 to control module connector C to take readings from the connector.
