S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Cut the cable harness as illustrated. This makes the cable harness easier to remove from the vehicle. Remove the remaining part of the cable harness with
connector.
Removing the old PEM
Raise the vehicle. PEM is located at the fuel tank on the right side.
Remove:
-
the connector from the PEM
-
the PEM from the vehicle
-
the cable harness from its mountings
-
the cable harness from the vehicle
Check that the fuel line sits in its clamps.
Installation
Replacing the cable harness
Replace the rear cable harness with a new one according to the Parts chart on page 1.
Note!
The photos at left illustrate the two different types of terminals on the two harnesses. Ensure that the correct parts are used.
Cable harness installation
Connect the connectors at the sill and fuel pump.
