volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Downloading Software And Replacing The Control Module|Page 1626 > < Downloading Software And Replacing The Control Module
Page 1
background image

Air Bag Control Module: Description and Operation
System Overview

System Overview

Control module

The supplemental restraint system module (SRS) handles functions for:

-

seat belt tensioners

-

side impact sensors

-

front impact sensor (certain markets and models only)

-

seat position sensors (XC90 USA/CDN only)

-

side impact protection (SIPS) bags

-

front driver and passenger airbags

-

inflatable curtains

-

SRS indication

-

passenger airbag indication

-

collision output signal

-

collision registration

-

adaptive steering column (XC90 USA/CDN only)

-

front seat belt buckles

-

switch on/off, front passenger airbag (not USA/CDN)

-

occupant weight sensor (OWS) (certain markets and models only)

The control module is in the transmission tunnel, between the gear selector lever and the parking brake.

The supplemental restraint system module (SRS) communicates with directly connected components and with other control modules via the Controller
Area Network (CAN).

The control module checks the input and output signals through an integrated diagnostic system. A diagnostic trouble code (DTC) is stored if the control
module detects a fault.
Any diagnostic trouble codes (DTCs) are stored in the control module memory. The data can be read off using VIDA.

The control module can process multiple collisions, frontal collisions, collisions from behind, side-on collisions and overturning.

The control module function can be easily checked by switching on the ignition. The SRS indicator lamp in the combined instrument panel must light up
when the key is in ignition positions I-III. The lamp goes out after a short while if no faults are detected. This means that the supplemental restraint
system (SRS) is functioning correctly.

Signals

The table below summarizes the input signals to and output signals from the supplemental restraint system module (SRS). The signal types are divided
into directly connected signals, LIN and CAN communication. The illustration below displays the same information with the Volvo component
designations.

Downloading Software And Replacing The Control Module|Page 1626 > < Downloading Software And Replacing The Control Module