S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
-
Find the four hole markings, they are positioned according to the distances as shown in the figure.
-
Pre drill the four holes from the inside. Use a Dia. 3 mm (1/8 inch.) drill bit
-
Drill out the holes. Use a Dia. 9 mm (3/8 inch.) drill bit.
-
Enlarge the holes in the bumper casing. Use a Dia. 31 mm (1 7/32 inch.) hole cutter (P/N 9814069).
-
Wash any dirt and stones off the bumper casing. Use a mild soap solution
-
Clean around the drilled holes. Use cleaner H (P/N 1161436-9), or a wet cloth. Allow to dry
-
Apply primer (P/N 9192679) around the holes. Allow to dry.
NOTE: It is important that primer is used otherwise the sensor holder will not mount securely in the bumper cover.
-
Clean the mating surface on the sensor holders. Use cleaner H (P/N 1161436-9), or a wet cloth. Allow to dry
-
Apply primer (P/N 9192679) on the cleaned sensor holder surfaces. Allow to dry.