S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
Power Seat Control Module: Service and Repair
Second Generation Power Seats
Power Seat Module (PSM), Replacing
Power seat module (PSM), replacing
Removing the control module
Raise the seat to its highest position.
For first generation power seats:
Remove the seat from the car. See Lifting seats in and out See: Seats/Service and Repair/Removal and Replacement.
For second generation power seats:
Remove the seat from the car. See Removing power seats, tilting See: Seats/Service and Repair/Removal and Replacement.
Remove the key.
Note! The key must be removed to ensure that the ignition is not switched on by mistake.
Wait 1 minute before starting work.
Remove the two screws.
Disconnect the connector.
Remove the control module.
Installing the control module
Install:
-
the control module
-
the connector
-
the two screws. The seat must be tightened to the floor. Tighten to 48 Nm.
-
the key