S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
Remove
-
oil dipstick's bracket.
-
the lower screws for the intake manifold a few turns.
Remove
-
the mounting screws in the upper row and the outer in the lower row.
-
the intake manifold by lifting it approximately 20 mm
Allow the crankcase ventilation hose to run through the intake manifold without disconnecting it from the flame trap.
Transferring components when replacing the intake manifold
-
Transfer the electronic throttle module.
Use a new gasket.
Tighten to 10 Nm.
Installing the intake manifold and gasket
Note! Make sure that the gasket faces are clean.
Install
-
a new gasket held in position by the lower screws for the intake manifold. Do not forget the clamp for the fuel line at the screw in the lower
row.
-
the intake manifold. Do not forget the crankcase ventilation hose. The hose must be inserted up through the gap between the second and third ducts
-
the three upper screws. Tighten all the screws starting from the middle with 20 Nm.
Finishing
