S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
Installing components
Raise the car. Install
-
the pipe screw that holds the turbocharger (TC) oil pressure pipe to the engine. Use new seal washers. Tighten to 38 Nm.
-
the turbocharger (TC) oil return line. Use a new gasket and sealing ring. Tighten to 12 Nm.
-
the clamp between the oil pressure pipe and the oil return line.
-
the screws and spacers at the manifold support bracket and cylinder block.
Tighten the three nuts that hold the front exhaust pipe to the turbocharger (TC). Tighten to 30 Nm.
-
the splash guard under the engine.
-
the plastic nuts for the hatch in the right fender liner
-
the right front wheel. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Lower the car
Tighten the pipe screw for the turbocharger (TC) oil pressure pipe. Tighten to 26 Nm.
Install
-
the heat deflector plate above the turbocharger (TC).
-
the ground strips between the cylinder head and the firewall.
-
the engine stabilizer brace between the suspension turrets.
Clamp the servo hose at the right engine stabilizer brace mounting.
-
the negative battery lead. First read Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Check
Replace the oil and oil filter if necessary.
Check
-
the engine oil level
-
the servo oil level
-
the coolant level.
Warm up the engine until the thermostat opens.
Check the engine for leaks.
Top up the coolant if necessary.