S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
Note! Place paper over the generator (GEN) as protection against oil.
Install:
-
the servo pump
-
the three mounting screws through the pulley. Tighten to 25 Nm
-
the stay at the rear edge of the power steering pump (applies only to diesel)
-
the return and pressure hose. Use a new O-ring on the pressure hose.
Remove the lock grip pliers from the return hose.
Installing the pressure hose
Tighten the screw clip on the sub-frame. Tighten to 10 Nm.
Install:
-
the pipe nipple in the pump. Tighten to 25 Nm
-
the lock bracket (2).
Tighten the screw (1). Tighten to 24 Nm.
Note! There may be a gap (3) of a few millimeters between the pipe coupling and the power steering pump. Bend the bracket so that the twelve
edged mounting on the bracket is on the nut.