S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
-
Insert a screwdriver in the hole (2) on the reverse of the steering wheel, at right angles to the rear surface of the steering wheel.
Insert the screwdriver as far as possible to determine the position of the end of the spring clip (1)
-
Position the end of the screwdriver on the top of the spring clip as illustrated
-
Pry the screwdriver upwards towards the upper edge of the hole (2) so that the end of the screwdriver presses the spring clip down (1) until one
side of the steering wheel module springs out and releases from the mounting
-
Turn the steering wheel a half turn in the opposite direction. Carry out the same operation on the other side.
-
Turn the steering wheel to the neutral position.
-
Fold the steering wheel module out
-
Remove the two connectors (1) for the ignition cables for the airbag. First press in the catches on the sides. Then pull the connectors straight out.
Note! The connectors are tightly secured. However, tools must not be used when removing.
-
Place the steering wheel module to one side.
Remove:
-
the connector (1)
-
the screw (2) that holds the steering wheel, leave the steering wheel in place.
