S60 T5 L5-2.4L Turbo VIN 54 B5244T5 (2006)
The three pins on the counterhold lock the automatic adjustment.
Position: 999 7068 Counterhold See: Tools and Equipment/999 7068 Counterhold as illustrated.
Ensure that all the three pins (see the illustration) go down into the correct side in front of the hooks for the automatic adjuster.
Press the counterhold ring against the pressure plate. Pull out the counterhold springs. Secure the three hooks in the holes in the clutch as illustrated.
Installing compression tool
Install: 999 5662 Compression tool See: Tools and Equipment/999 5662 Compression Tool , together with: 998 9742 Conversion kit See: Tools and
Equipment/998 9742 Conversion Kit , on the clutch.
Align the hooks on the tool with the markings made previously. Ensure that the hooks grip the clutch housing properly.
Center the compression tool and tighten the screw to light contact against the diaphragm spring. At the same time, check that the hooks on the tool are in
position.
Note the position of the handle with slots. Then screw in by not more than two turns.
Remove the clutch and clutch driven plate. The tools can remain in place on the clutch if it is to be reused.
Note! Take care not to trap any fingers when removing the tool.
Checking the clutch
