S70 L5-2.4L VIN 61 B5244S (2000)
Yes
-
See: Checking Signal to Starter Relay/Checking Signal
Yes
-
See: Checking Signal to Starter Relay/Checking Programming
Checking Signal
Checking Signal
-
Ignition on.
Read the starter relay status.
The value should be ON when the ignition is on.
OK
-
See: Checking Signal to Starter Relay/Checking Cables
Not OK -
See: Checking Signal to Starter Relay/Replacing Component
Checking Cables
Checking Cables
Check the cable between VQLA control module #B2 1 and starter relay #4 for an open-circuit See: Diagnostic Trouble Code Tests and Associated
Procedures/Related Tests and Information/Checking Wiring and Terminals - Permanent Faults
Check that there is voltage to the starter relay #2 when the ignition is in position three.
Hint: For further information about the circuit, refer to the "Wiring diagrams".
Remedy as necessary.
Replacing Component
Replacing Component
Try a new VGLA control module.
After performing this procedure See: Checking Signal to Starter Relay/Verification
Checking Programming
Checking Programming
