volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Reading and Clearing Diagnostic Trouble Codes|Page 8408 > < Reading and Clearing Diagnostic Trouble Codes|Page 8406
Page 41
background image

Check the cable between VGLA control module #A19 and the lock unit in tailgate/trunk lid terminal 1 and the cable between the lock unit in the
tailgate/trunk lid terminal 4 and ground for an open-circuit, See: Diagnostic Trouble Code Tests and Associated Procedures/Related Tests and
Information/Checking Wiring and Terminals - Permanent Faults 
 
Were any faults found in the cables?

Yes

-

See: Checking Tailgate Switch/Verification 

No

-

See: Checking Tailgate Switch/Replacing Component

Replacing Component

Replacing Component

Replace the trunk lid lock unit.

After performing this procedure See: Checking Tailgate Switch/Verification

Verification

Verification

Hint:  After carrying out the repair check that the fault has been remedied as follows:

-

Ignition off.

-

Reconnect connectors, reinstall components.

-

Ignition on.

-

Truck lid/tailgate open

Read status for the door switch in the tailgate/trunk lid The value should be LOW when the tailgate/trunk lid is open.

Fault Tracing Information

Fault Tracing Information

Condition

-

No diagnostic trouble codes (DTCs) stored

Possible source

-

Open-circuit in signal cables from door lock switch.

-

Open-circuit in door lock switch ground lead

-

Fault in door lock switch in driver's door lock unit.

Checking The Locking Signal From The Door Lock Switch

Reading and Clearing Diagnostic Trouble Codes|Page 8408 > < Reading and Clearing Diagnostic Trouble Codes|Page 8406