S70 L5-2.4L VIN 61 B5244S (2000)
Note: The ABS hydraulic modulator is filled with brake fluid. It is important that the plugs are not removed until the brake pipes are to be connected.
^
Check and install control module on the ABS hydraulic modulator according to Replacing control module. Install screws. Tighten to 1.8 Nm (1.33
ft. lbs.).
^
Install the new ABS hydraulic modulator on the bracket and tighten mounting screws. Tighten to 8 Nm (5.90 ft. lbs.).
^
Hold the vacuum hose to one side and carefully install the bracket in the car.
^
Connect the pump motor connector to the control module.
^
Tighten mounting screws to 8 Nm (5.90 ft. lbs.).
Cars with TRACS
Insert the vacuum hose between the bracket and ABS hydraulic modulator. Check that the check valve and rubber seal are intact. Connect the check
valve to the power brake booster.
Continued ABS hydraulic modulator installation
^
Connect connector to the control module and pump motor.
^
Remove plugs and connect the brake pipes to the ABS hydraulic modulator and master cylinder. Tighten to 14 Nm (10.33 ft. lbs.).
^
Release the brake pedal.
^
Install air cleaner (ACL) housing with intake pipe and air preheating hose.
^
Connect ignition cable to ignition coil.
On cars with Turbocharger (TC) engines
Install: Intake pipe between Air Cleaner (ACL) and Turbocharger (TC).
