S70 L5-2.4L VIN 61 B5244S (2000)
Remove:
-
the two screws (1) securing the inner timing cover to the cylinder block
-
the lower belt guard at the oil pump housing.
Press the inner timing cover off the flange around the coolant pump. Start at the lower edge of the pump.
Hold the cover out of the way. Remove the piston cooling valve (2) and the seal washer.
3
Installing components
Install:
-
a new piston cooling valve (2) with a new seal washer. Tighten to 35 Nm.
-
the inner timing cover. First press the cover into place over the flange at the top of the coolant pump. Then press the remaining section of the cover
into place over the flange around the pump. Check that the cover is correctly positioned.
-
the we screws (1) securing the inner timing cover to the cylinder block.
-
the lower belt guard.
4
Installing the timing belt
Install:
-
the screw securing the inner timing cover to the cylinder head.
-
idler pulley. Tighten to 25 Nm.
-
the timing belt tensioner. Screw in the center screw by hand. Ensure that the fork on the tensioner centers above the cylinder block rib. Check that the