S70 L5-2.4L VIN 61 B5244S (2000)
2
Removing the oil sump
Remove the oil sump, see VADIS:
Repair and Installation
Function group 21
Oil sump, replace
3
Removing the cylinder head
All variants:
Remove the cylinder head, see VADIS
Installation Function
Function group 21
Replacing the cylinder head/gasket
4
Removing the pistons
Note!
On later version engines the connecting rod and the end cap
mating surfaces are aligned by a dedicated fracture surface.
Note the markings on the connecting rod and the end
caps and the direction in which they are installed, forward,
rearward, left, right.
On earlier version engines the connecting rod and end cap mating
surfaces are aligned by serrations. NOT all connecting rods
and end caps may be marked as described above. If markings
are in place then note location as described above. If NO
markings exist stamp or etch the appropriate cylinder number
on each all facing the same direction.
Turn the crankshaft to bottom dead center to access the two
connecting end cap bolts.
Remove the end cap bolts.
5