S70 L5-2.4L VIN 61 B5244S (2000)
Bending attachment
4
Note!
The following illustrations do not show the protective tape. The tape must remain in place throughout the entire procedure.
Insert screwdriver behind the attachment. Bend attachment 45 degrees inward.
Making kinks
5
Using a small chisel, make a mark on both sides of the center louver. Mark should be in-line with the straight cut side of the louver.
See Illustration.
Grab attachment with a pair of channel locks.
6
Using a flat blade screwdriver, press down on one of the marks, at the same time, bend grate over with channel locks.